The quality module street lamp is one of the important equipment for engineering lighting. To put it bluntly, the quality module street lamp should let the light wash the wall like water. It is mainly used for the construction of interior decoration lighting fixtures, and it is also used to describe large and medium-sized projects. The outline of the building. With the development trend of lighting fixtures, the role of quality module street lamps is getting better and better, and there are more and more methods. It is no longer limited to using concealed quality module street lamps. There are also different installation processes for quality module street lamps. different. Today, let's take a brief look at the installation process of several common quality module street lamps and the application fields of quality module street lamps.

1. First, use an electric soldering iron and solder bar to weld the LED lamp beads on the solar cell for reservation.
2. Then test the spot-welded wood board to see if there is empty welding or no light, so that according to the basic embrittlement, it can ensure that the promotion of the LED quality module street lamp and the LED lamp beads are intact.
3. After the light test is over, put heat-dissipating silica gel on the back of the solar cell, and put the board into the case. The heat-conducting silica gel is to release the attention of the LED lamp beads to the lamp arm, which can prevent the lamp from sub-light decay.
4. Prepare the process in advance. Weld the switching power supply on the positive and negative sides of the solar cell, and then bind the two sides with tape to carry out glue.
5. After the glue is made, cover the laminated glass to construct a moisture-proof quality module street lamp. There is no need to use structural glue. It is not a waterproof material, and structural glue must be used. After the laminated glass is covered, plug the leak head.

工程施工方法: 1.绝缘层检测: 用接地振动器监测电线之间和对地的接地电阻，检查电缆是否完好，是否有电。铜芯电缆应对地充电和放电。电缆的顶部用柔软的橡皮布密封，然后用胶带包裹。2、质量模块路灯安装: (1) 同一位置的路灯的长宽比 (从光源到路面) 、仰角、安登方位要保持 -- 一致。(2) 照明安装的垂直轴和拾取臂的垂直轴应相同，照明灯具的水平线应与地板平行，并应估计拧紧后应无倾斜。(3) 灯座固定牢固，可调式灯座应根据设计调整到合理位置，灯座接线应符合要求。